6. CLEANING / MAINTENANCE
Initial Cleaning: |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Prior to operating your new griddle, thoroughly wash the griddle surface and the exterior with a mild | |||||||||||||||
| detergent or soap solution. Do not use abrasive cleaners since this might damage the cabinet finish. | |||||||||||||||
| CAUTION:Cleanthe |
| atleast once month.Makesure | ventopeningis | andnot |
| ||||||||||
! | blockedwellanditncouldanywayshorten.Failureregulatorthlifedosoof thewillproductcause.variations inpressurthe.Yourunitwillnotfuctionopen | as | ! | |||||||||||||
| If the stainless s e surfaces become discolored, sc b by rubbing only in the direc ion of the | |||||||||||||||
| finish | gr | in. |
|
|
|
|
|
|
|
|
|
|
|
| |
Cleaning: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
1 | Always turn unit | ff and | llow it to cool co | pletely b fore cl | aning. Clean thoroughly before first | |||||||||||
| use. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
2 | After | ach us , clean the gri | dle with wire brush or flexible | patula. |
|
|
|
| ||||||||
3 | On |
| day, thoroughly c ean spl | h b | k, sides and front. Remove the grease drawer, empty it and | |||||||||||
| wash it out. |
|
|
|
|
|
|
|
|
|
|
|
| |||
4 | On |
| week, clean the griddle surfa | hor | ughly. If nec | ssary, se a griddle stone, wire brush or | ||||||||||
| plate. |
| the surface. Rub with the grain of the m tal while the griddle | still w | rm. A detergent | |||||||||||
| st | el wool | ||||||||||||||
| m | y be used on | plate su | ce to help cle | i ; but, care must be taken to be sure the detergent is | |||||||||||
| th | roughly removed. Aft | remov | f the deterge t, the surface of the plate | ho ld then be covered | |||||||||||
| with | th | film of | il to prev | nt rusting. Cl an stainless | fac | s wi h a damp cloth | d polish with a | ||||||||
| soft dry cloth. To remove disco ra | , use a non- brasive clea er. After each "weekly" cleaning, | ||||||||||||||
| the gri dle must be seas | ned | gain. If the griddle usage is very high, the "weekly" cleaning | |||||||||||||
| pr | edures may be done more often than once week. |
|
|
|
|
|
| ||||||||
Extended Shutdown:
Turn the manual shutoff valve to "OFF"; (field installed valve not supplied by the manufacturer); turn a control knobs to the "OFF" position; and shut off the pilot flame by turning the adjustment on the pilot valve.
If the griddle is to be shut down for an extended period, put a heavy coat of grease over the griddle
Service / Repair
NOTE: THIS APPLIANCE MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
NOTE: Parts protected by the manufacturer or his agent are not to be adjusted by the installer unless the installer is an authorized service agent.
If you have any questions or problems contact your nearest APW Wyott Service Representative.
CONVERSION (Not Available in the European Community
Instructions are for conversion from Natural Gas to Propane (L.P.) on all models GGT.
The conversion should be done before connecting the unit to the gas supply.
1Remove the knobs and front panel.
2Remove the supply tubes that go between the valves and the orifice fittings.
3Remove the orifice fittings from the firebox. Change the orifices to the size recommended for propane (L.P.).
4Replace the orifice fittings into the firebox.
5Replace the supply tubes between the valves and the orifice fittings.
6Replace the front panel, grease drawer and knobs.
7Reverse plug in pressure regulator. The marking on the plug facing out should match gas supply.
8 | Continue with the installation. | 8 |
