APW Wyott HFW-AT-2D 6D, HFW-AT-2 6 General Operation Instructions, General Cleaning Instructions

Models: HFW-AT-2 6 HFW-AT-2D 6D

1 12
Download 12 pages 63.39 Kb
Page 6
Image 6
3. GENERAL OPERATION INSTRUCTIONS

 

 

3. GENERAL OPERATION INSTRUCTIONS

1.

All foodservice equipment should be operated by trained personnel.

2.

Do not allow your customers to come in contact with any surface labeled ''CAUTION HOT”.

3.

Where applicable, DO NOT cook, warm or hold food directly in liner pans (well pan). Always use

 

steam table pans/insets, etc.

4.

Never hold food below 150F (66.6C).

5.

Add hot water 120 - 140F (50 - 60C) to well pan.

 

￿

HFW-AT-2 THRU 6 (12 X 20 pan) use: 3-3/4qts (15 cups) (3-1/2 liter)

6.Turn thermostat control to (10) setting. Preheat for approximately 30 minutes.

7.Place covered inset with preheated product into well.

8.Readjust control inset to “4” “6” setting depending on the amount and/or thickness of product.

9.Keep inset / steam table pan(s) covered to maintain ideal serving temperature.

10.Do not let WELL RUN DRY.

4.GENERAL CLEANING INSTRUCTIONS

1.NEVER clean any electrical unit by immersing it in water. Unplug unit off before surface cleaning.

2.Always clean equipment thoroughly before first use. Clean unit daily. Except where note on charts: use warm, soapy water. Mild Cleansers & PLASTIC scouring pads made be used to remove baked- on food & water scale.

3.Turn off electrical units before cleaning or service. All service should be preformed by an APW Wyott authorized service agency.

4.DO NOT use chlorides or chloride-based products in this unit. Chloride-based products and improper cleaning may cause corrosion and pitting

Failure to comply with these instructions may void unit warranty.

5. GENERAL TROUBLESHOOTING

ALWAYS ASK & CHECK:

1. Is the unit connected to a live power source?

2. Check the circuit breaker.

3. Is power switch on & pilot light glowing?

4. Check rating label. Are you operating unit on proper voltage?

If the above checks out, and you still have problems,6 call an APW Wyott authorized service agency.

6. WARRANTY PROCEDURE

If warranty service is needed on your APW Wyott equipment, follow these steps: Secure the model and serial number from the rating label on your appliance.

Consult the enclosed directory, find the service agency nearest you, call the number listed or the 24-hour toll free service hot line, 1-800-733-2203. If there is not a service agency listed for your area, the parts distributor will provide service for your appliance.

To order parts, consult the enclosed directory. The parts distributor is listed at the beginning of each state listing. The parts distributors have a complete stock of parts for your appliance.

24 Hour Toll Free Service Hot Line

Service Hotline (800) 733-2203

Page 6
Image 6
APW Wyott HFW-AT-2D 6D, HFW-AT-2 6 General Operation Instructions, General Cleaning Instructions, General Troubleshooting