Kohler 24RCL manual Changing Settings on the RDC2 Controller

Changing Settings on the RDC2 Controller

1. Press the Select button to enter the main menu.

Overview ---->

Press: Display: 1.2 h

2.Press the down arrow button until the desired menu is displayed. See Figure 3-7. Date and Time are used for this example.

Press:	Display:	Date	---->
		and Time

3.Press the Select button to enter the Date and Time menu.

Press:	Display:	Date:
		05Dec2013

4.To change the date and time settings, press the Select button again. The year will flash.

Press:	Display:	Date:
		05Dec2013

5.Press the up or down arrow buttons to change the year.

		Display:	Date:
Press:	OR
			05Dec2014

6.When the correct year is shown, press the Select button. The year is saved and the next setting (month) flashes.

Press:	Display:	Date:
		05Dec2014

7.Repeat steps 5 and 6, using the arrow and select buttons to set the month and the date.

8.When the correct date is shown, press the Select button. The saved date is shown.

Press:	Display:	Date:
		03Jan2014

9.Press the down arrow button to step to the next menu.

Press:	Display:	Time:
		01:49pm

10.Repeat steps 5 and 6, using the arrow and select buttons to set and save the time.

Note: To change from am to pm, press the up arrow key to increase the hour until the correct hour and pm is displayed.

11.Repeat to set the time format to 12 hr. or 24 hr.

12.Press the down arrow button. Return is displayed.

Press: Display: <---- Return

13.Press Select to return to the Date and Time menu.

Press:	Display:	Date ---->
		and Time

14.Press the Up or Down arrow buttons to step to a different menu.

15.Press Auto to signal the controller to exit the menus and return to the generator set status display.

Press:	Display:	Genset State
		Standby
	AUTO

Note: If no buttons are pressed, the controller returns to the status display after 5 minutes.

Figure 3-6Changing Settings

TP-6905 6/14 Section 3 RDC2 Controller Operation 33