Kohler 24RCL manual OnCue Plus Password

3.17.2Networking Configuration Submenu (OnCue Plus Password)

The networking Configuration menu includes settings used for communication with the Kohlerr OnCuer Plus Generator Management System.

For most applications, DHCP is enabled and the IP settings cannot be changed from the controller keypad. If DHCP is enabled, IP parameters are not displayed.

If DHCP is disabled (i.e., if a static IP address is required), then the IP parameters can be modified. For applications that require static IP addresses, press and hold the select button to enable editing, disable DHCP, and then step to the next parameters and enter the information.

If an error occurs while setting a parameter, an error message is displayed and then the controller exits the edit mode. Previous settings are preserved.

OnCue Plus Password

For the initial OnCue Plus setup, you will be required to reset the OnCue Plus password on the RDC2 controller, and then enter it into the OnCue Plus software. To reset the password, follow the instructions in Figure 3-19.

Note: The password is displayed for only 10 seconds. Be sure to write down the password and serial number.

A new password is generated each time the reset password procedure is performed. If the password is reset after the OnCue Plus system has been set up, the connection will be lost. Enter the new password in OnCue Plus to reconnect.

Networking---->

Information

Networking---->

Status

Networking

Configuration

Reset OnCue Password

DHCP:

Enabled

<---- Return

HOLD

Reset OnCue

Password? No

UP arrow for YES,

Down arrow for NO.

Reset OnCue

Password? Yes

Press Select to enter YES or NO as displayed. New password is displayed for approximately 10 seconds.

S/N: #######

New PW: #####

tp6804

Figure 3-19Network Configuration Submenu

44 Section 3 RDC2 Controller Operation TP-6905 6/14