3.6 Controller Menus
The following sections show the RDC2 controller menus and submenus. Use the Select button and the up and down arrow buttons to navigate the menus as shown in the diagrams.
Note: Use caution when navigating the controller menus. In some menus, pressing the Select button can enable editing of the controller settings. Changing the settings to incorrect values can adversely affect generator set operation or render the unit inoperable.
If a setting on the controller display is flashing, edit mode has been enabled. Press the OFF or AUTO button to exit the edit mode.
3.7 Main Menu
Press the Select button once to bring up the main menu. Overview is displayed. See Figure
The controller will exit the main menu after 5 minutes if no buttons are pressed. To exit the main menu immediately, press the controller’s OFF or AUTO button.
|
|
|
|
|
|
|
|
|
|
|
Status |
|
|
|
| Overview |
| ||||
Displays |
|
|
|
| 1.2 h |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Press the Up and Down arrow buttons to move between menus.
Press OFF or AUTO to exit the menus.
Engine
Metering
Metering
ATS
Configuration *
Date
and Time
Genset
Information
Network
Information
Genset
Run Time
PIM
Status
Genset
System
Load
Control
ATS
Status
Event
* ATS configuration appears only if a Model RXT transfer switch is connected. | tp6804 |
|
Figure
34 Section 3 RDC2 Controller Operation |