Marantz SR6009 owner manual Error messages, Examples Error details Measures

Contents Connections Playback Settings Tips Appendix

Error messages

An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.

Examples		Error details		Measures
No speakers found.	0	Sound calibration microphone is not	0	Connect the included Sound calibration microphone to the
		detected.		SETUP MIC jack of this unit.
	0	Not all speakers could be detected.	0	Check the speaker connections.
Ambient noise is too high or level is too	0	There is too much noise in the room.	0	Either turn off any device generating noise or move it away.
low			0	Perform again when the surroundings are quieter.
	0	Speaker or subwoofer sound is too low.	0	Check the speaker installation and the direction in which the
				speakers are facing.
			0	Adjust the subwoofer’s volume.
Front R : None	0	The displayed speaker could not be	0	Check the connections of the displayed speaker.
		detected.
Front R : Phase	0	The displayed speaker is connected with the	0	Check the polarity of the displayed speaker.
		polarity reversed.	0	For some speakers, this error message may be displayed
				even if the speaker is properly connected. If you are sure the
				connection is correct, press p to select “Ignore”, then press
				ENTER.

Front panel Display Rear panel 187 Remote Index