Marantz SR6009 owner manual Speaker connection, 4ohms

Contents Connections Playback Settings Tips Appendix

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

0Disconnect this unit’s power plug from the power outlet before connecting the speakers. Also, turn off the subwoofer.

0Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and - sides touch each other. (“Protection circuit” (v p. 263))

0Never touch the speaker terminals while the power cord is connected. Doing so could result in electric shock. When the “Setup Assistant” (page 9 in the separate “Quick Start Guide”) is running, follow the instructions in the “Setup Assistant” screen for making connections. (Power is not supplied to the speaker terminals while the “Setup Assistant” is running.)

0Use speakers with an impedance of 4 – 16 Ω/ohms.

NOTE

0Carry out the following settings when using a speaker with an impedance of 4 – 6 Ω/ohms.

1.Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3 seconds.

“Video Format < PAL>” appears on the display.

2.Press DIMMER on the main unit twice. “Sp.Imp. <8ohms>” appears on the display.

3.Press TUNER PRESET CH + or TUNER PRESET CH － on the main unit to select the impedance.

6ohms:	Select when the impedance for any of the connected speakers is
	6 Ω/ohms.
4ohms:	Select when the impedance for any of the connected speakers is
	4 Ω/ohms.

4. Press the main unit’s STATUS to complete the setting.

Front panel Display Rear panel 31 Remote Index