Reinstalling the Suction Cover

with ceramic ring. Caution: Do not grip impeller sleeve.

3.Reinstall the wear ring over the impeller hub in correct orientation.

1.Inspect the o-ring for damage. Replace if necessary.

2.Properly install the o-ring on the cover before mounting the cover to the volute.

3.Cover can be mounted to the volute in one orientation only. An ‘aligning’ feature is built-in with each part, to ensure proper mounting. When properly aligned, the cover should slide in easily.

4.Secure the cover to the volute with screws. Tighten all screws alternately (crisscrossing the cover) to achieve proper o-ring compression and cover seating.

5.Rotate the impeller by hand to make sure that it is rotating freely, without any interference.

Reconnecting the Pump Unit

1.Clean the seals, gaskets, or o-rings of the plumbing connectors. Replace if cracked, worn, or damaged.

2.Reconnect the plumbing lines to the pump. Hand tighten only.

3.Be sure that the pump unit is secured properly to the platform or base, if applicable. Tighten the bolts if necessary.

4.Reconnect the power supply. Be sure that all wires are properly and securely connected.

CAUTION: BEFORE TURNING THE POWER ON, BE SURE THAT: 1) THERE IS AN ADEQUATE AMOUNT OF WATER IN THE SYSTEM; 2) ALL VALVES ARE OPEN TO ALLOW WATER CIRCULATION; 3) ALL CONNECTORS AND FITTINGS ARE PROPERLY ALIGNED AND SECURE.

FLO-MASTER®"TMCP" SERIES PUMPS LIMITED WARRANTY

Aqua-Flo, Inc.

WARRANTS TO:	Third year	60%

____________________________________________	Fourth year	40%
________________________________________________________________________________________________	Fifth year	20%
the original retail purchaser only, that the	EXCLUSIONS
products they manufacture are free from defects in	1. This warranty shall not apply to any failures
material and/or workmanship for a period of five years
(pump seals warranty for 30 days) from date of purchase.	resulting from negligence, abuse, misuse, misapplication,
If within the first two years, any such products shall prove	improper installation, alteration or modification, chemical
defective, it shall be repaired or replaced at AQUA-FLO’S	corrosion, or improper maintenance.
option as follows:	2. Any items manufactured by other companies

The original retail purchaser shall first contact the	and used by AQUA-FLO in its products may carry
installing dealer, as soon as possible after discovery of	warranties by the original manufacturers.
the defect, but in no event later that the expiration date of	3. AQUA-FLO is not liable for incidental or
this warranty. Or upon notification,
AQUA-FLO, INC.	consequential damages, loss of time, inconvenience,
	incidental expenses, labor or material charges in
Customer Service Department	connection with removal or replacement of the
P.O. Box 2526, Chino, CA 91708	equipment.
will advise the consumer of the address to which	AQUA-FLO is not responsible for any implied
the defective item may be shipped, together with the	warranties or representations by others and the foregoing
model number, serial number and date of purchase of	warranty is exclusive and in lieu of all warranties provided
item claimed to be defective. The consumer must pay for	herein.
all shipping charges.	Some states do not allow the exclusion or

If within the years three through five any such	limitation of incidental or consequential damages, so the
products shall prove defective, the original retail	above limitation or exclusion may not apply to you.
purchaser shall be entitled to purchase replacement	This warranty gives you specific legal rights and
equipment or components at the following percentage off
the current published list price:	you may also have other rights, which vary from state to
	state.

PUMPS FOR THE LEISURE WATER INDUSTRY

Box 2526 / Chino, CA 91710

Shipping: 5651 Schaefer Ave. / Chino, CA 91710

FAX: 909/627-5660 TEL: 909/591-7453

Aqua Flo Tub-Master Series FLO-MASTER TMCP SERIES PUMPS LIMITED WARRANTY Aqua-Flo, Inc

Models: Tub-Master Series