PROGRAMMING AND OPERATION
Basic Programming
Control Panel Features and Functions
The first line of the display typically indicates the Purifier Output Level
in percent (%), or whether the system is in Boost or
the temperature in Fahrenheit or Celsius, and purifier on/off mode. A small dot in the bottom right corner indicates the
In pH mode, display will toggle between Purifier display to the pH Feed display (then the Acid Meter but only when the acid pump is actually feeding).
In TC mode, display will toggle between normal display, ORP measurement (set point), and pH measurement (set point)
Check system – Red LED flashes to warn that attention is needed. A warning message will also be displayed.
Press the Up or Down Arrow to:
•Set Chlorine Level % (and ORP/pH levels when optional Digital TC components are installed)
•Scroll through Menus and sub- Menus
•Increase or Decrease programming values for menus
Pool Pilot ™
P u r i f i e r 5 0 % 4:21 P 82F ON .
Check
System
Boost Menu Select Pump
Press the Pump button to manually override a stored program for:
•Turning the pump on, off, or off for maintenance.
•Changing the speed of a 2- speed pump.
Not applicable if the Set Relay 1 is programmed for “Acid Pump” or “Relay not used”.
Press Boost to start 24- hour boost mode, or press and hold Boost for
8seconds to start 72- hour boost mode. Press Boost again to cancel boost.
Press Menu to leave normal operation to access the menus for programming and diagnostics
Press the Select button to choose the item on the display
26