Arboria Heritage Arbor STEP 6: CONNECTING WING TO ARBOR PANELS AND POSTS SLEEVE , STEP 7: SHIMMING AND TRIMMING POST SLEEVE

• Use shims, adhesive and finish nails or screws to secure
the shims and sleeve firmly to the 4x4 post. Be sure to
shim both the top and bottom of the post.
• Trim shims flush with the sleeve surface.
• Trim base molding to fit the post sleeve.
• Using wood adhesive and galvanized finishing nails
connect all four sides of the base molding to the post
sleeve.
• Finish the installation by capping the post sleeve with
the post caps, use wood adhesive or finish nails to
secure the post cap to the post sleeve.
Congratulations! You’ve done it!
STEP 6: CONNECTING WING TO ARBOR PANELS AND POSTS SLEEVE
STEP 7: SHIMMING AND TRIMMING POST SLEEVE
Align the lattice of wing-panel to the lattice of the arbor’s side
panel.
Install the wing-panel panel using 2 1/2” washer head screws.
You will need two on the top and two on the bottom through the
frame of the wing -panel.
These self-tapping screws will help prevent splitting wood.
445.35.100 4 of 4 9/29/2006
Division of LWO Corp. / P.O. Box 17125 / 3841 North Columbia Boulevard / Portland, Oregon
503-286-5372 / fax 503-286-4092