The remote-control and trigger inputs

The REMOTE IN input can be used to pass RC5 codes to the DV137 if it is installed in a position (or system) where infrared cannot be used. If this is required, please contact your dealer for further information.

The trigger in input can be used to switch the DV137 in and out of stand-by. Connecting the trigger output of your Arcam amplifier (or other compatible device), will cause the DV137 to come out of stand-by automatically when the amplifier is switched on, returning to stand-by when the amplifier is switched off. Please see your amplifier handbook for further information.

In normal use there is no need to make any connections to these inputs.

Using the remote control

The remote control input requires a mono

3.5mm jack, with the

tip active and the sleeve

grounded.

The remote control signals

must be in modulated RC5

format (at 36kHz), with a

voltage level of between

5V and 12V.

The functions of buttons on the remote control are described on pages 8 and 9 (CR-515) or pages 10 and 11 (CR-415).

Please keep in mind the following when using the remote control:

<Ensure that there are no obstacles between the remote control and the remote sensor on the DV137. The remote has a range of about seven meters. (If the remote sensor is obscured, the remote control input jack on the rear panel is available. Please contact your dealer for further information.)

<Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the DV137.

<Replace the batteries when you notice a reduction in the operating range of the remote control.

Notes on inserting the remote control batteries

<Incorrect use of batteries can result in hazards such as leakage and bursting.

<Do not mix old and new batteries together.

<Do not use different kinds of battery together—although they may look similar, different batteries may have different voltages.

<Ensure that the plus (+) and minus () ends of each battery match the indications in the battery compartment.

<Remove batteries from equipment that is not going to be used for a month or more.

<When disposing of used batteries, please comply with governmental (or other) regulations that apply in your country or area.

Connecting to a power supply

Inserting batteries into the CR‑515 remote control

A. Open the battery compartment by pressing the button on the back of the remote control.

B. Insert four ‘AAA’ batteries into the battery compartment, following the polarity indications given inside the compartment.

C. Press the battery cover back into position.

Mains lead

The appliance is normally supplied with a moulded mains plug already fitted to the lead. Check that the plug supplied with the unit fits your supply and that your mains supply voltage agrees with the voltage setting (115V or 230V) indicated on the rear panel of the unit. If for any reason the plug needs to be removed, it must be disposed of immediately and securely, as it is a potential shock hazard when inserted into the mains socket.

If your mains supply voltage or mains plug is different, or you require a new lead, please consult your Arcam dealer.

Plugging in

Push the plug (IEC line socket) of the power cable supplied with the unit into the socket (POWER INLET) in the back of the unit. Make sure it is pushed in firmly.

Put the plug on the other end of the cable into your power supply socket and switch the socket on.

Inserting batteries into the CR‑415 remote control

A. Open the cover of the remote control battery compartment

B. Insert two ‘AAA’ batteries into the battery compartment, following the polarity indications given inside the compartment.

C. Slide and press the battery cover back into position.

DV137

E-6

Page 6
Image 6
Arcam DV137 manual Remote-control and trigger inputs, Using the remote control, Connecting to a power supply