connection
Sub/full range+sat system |
|
|
|
| |
This is a |
|
|
|
| |
Solo Movie 5.1) where full range L and R speakers |
|
|
|
| |
are combined with satellite (or with full range) rear |
|
| LS | RS | |
speakers.The system should be connected with |
| PRE OUT SUB |
| ||
|
|
| |||
both the Sub, Subwoofer or LFE output connected to |
| PRE OUT RIGHT |
|
| |
| PRE OUT LEFT |
|
| ||
IN LFE and Left/Right preamplifier outputs attached to |
|
|
| ||
|
|
|
| ||
IN L/IN R on Logo. |
|
|
|
| |
In such systems, Logo can be set up to work with two |
|
|
|
| |
crossover frequencies. One frequency is set up for the |
|
|
|
| |
rear speakers using the surround amplifier crossover, |
|
| L |
| |
and one frequency for the full range Left and Right |
|
|
| ||
|
| C | R | ||
speakers, using the Logo crossover. | IN R | IN L | |||
|
| ||||
|
|
| |||
|
| IN LFE |
|
|
Direct mode in Arcam surround amplifiers
Stereo system with no LFE
This is a typical
L-
L+
L+ | L- |
|
|
R+ | R- | PRE OUT | PRE OUT |
|
| RIGHT | LEFT |
R- |
|
R+ | IN L |
| IN R |
If you wish to have your system set up to use the crossover in the surround amplifier for 5.1 or 7.1 material, but use Left and Right full range speakers with Logo filling in for
Connect the amplifier and Logo as in the Sub/full range+sat system diagram. In the amplifier, set up all speakers to ‘Small’; this redirects bass to Logo via the LFE channel.To use the system’s full range, activate ‘Direct mode’ for
Sub/sat system
This is a |
|
Solo Movie 5.1) where all the main speakers are |
|
satellite speakers, defined as ‘Small’. Logo is connected |
|
to output marked Sub, Subwoofer or LFE. | PRE OUT SUB |
The LFE input bypasses the crossover in Logo, so the crossover frequency should be set by the surround sound amplifier. For the crossover setting, please see the response of your satellite speakers which may vary from around 70Hz for large satellites, to 150Hz for small satellites.We recommend 80Hz as a starting point if you are unsure.
IN LFE
LS | RS |
L |
|
C | R |