Installation: A85 integrated amplifier
VOLTAGE
SELECT
230V
POWER INLET
1 2
|
| SP2 |
|
TRIG | 4 – 16 OHMS | L | |
OUT |
|
| |
|
| SP1 | INTEGRATED |
|
| R | |
REMOTE |
|
| |
IN |
|
|
|
+ | R – | + L – | PRE/PWR |
PWR IN PRE OUT |
3 | 4 | 5 6 7 |
L
| PHONO |
| R |
L | MM |
MC |
R
RECORD | PLAY | RECORD | PLAY |
|
|
|
|
|
OUT | IN | OUT | IN |
|
|
|
|
|
TAPE 1 | VCR/TAPE 2 | DVD | AV | TUNER | CD | AUX |
8 9 bk bl bm bn bo bp bq br
Positioning the unit
Place your amplifier on a level, firm surface.
Avoid placing the unit in direct sunlight or near sources of heat or damp.
Ensure adequate ventilation. Do not place the unit in an enclosed space such as a bookcase or cabinet as both of these will impede air flow through the ventilation slots.
+ | – | Arcam A85 amplifier | – |
+ | |||
| R |
| L |
+ | – | + | – |
Right |
|
| Left |
speaker |
|
| speaker |
Connecting to loudspeakers
You can connect one or two pairs of loudspeakers to your amplifier, provided each pair is rated between
To connect one pair of loudspeakers, use the SP1 terminals.
SP1 and SP2 terminals 4
Both sets of loudspeaker terminals can be switched off by pressing the MUTE button on the remote control. To switch SP1 and SP2 independently, use the front panel switch 7 (see page 6) or the remote control (see page 9).
Your amplifier is fitted with loudspeaker terminals to BFA (British Federation of Audio) standard specification.
BFA loudspeaker terminals
The terminal will accept spade terminals, bare wires or a BFA plug. BFA plugs are available from your Arcam dealer. To connect a bare wire or spade terminal, unscrew the red (or black) part of the loudspeaker terminal first.
Insert the wire or spade terminal and screw it back up.
CAUTION: Do not over tighten the loudspeaker terminals or use a wrench, pliers, etc., as this could cause damage to the terminals which will not be covered under warranty.
A85/P85
Wiring your loudspeakers
Connect the right speaker to the terminals on the back of your amplifier marked R and the left speaker to the terminals marked L.
Connect your loudspeakers so that the red (positive/+) terminal on each loudspeaker is connected to the red (positive/+) terminal on the amplifier. Your loudspeaker cables may be marked to show polarity (negative/– and positive/+), if not, then the positive terminal can usually be identified by a ridge or coloured marking.
Now connect your loudspeakers’ black
Ensure that no stray strands of inner wires are allowed to touch another cable or the amplifier’s casing. This can cause a short circuit and damage your amplifier!
4