Battery installation
This camera uses 4 AAA alkaline batteries. (Do not mix batteries of different types.)
1.When replacing batteries, make sure the camera is turned off.
2.Turn the camera upside down and slide the battery door toward the side of the camera to unlatch then swing it open.
3.Install the batteries according to the polarity diagram on the inside panel of the battery compartment door.
4.Close the battery door and slide it inward to lock in place.
WARNING: Removing the batteries will erase the camera’s
Power (sleep-mode on/off button)
Pressing the button marked POWER located on the top of the camera will either wake up the camera or put it into sleep mode. The camera automatically defaults to sleep mode approx. 30 seconds after
NOTE: To completely devoid the camera of power, and to preserve battery life, remove the batteries.
Installing the CF card
This camera accepts only CF type I cards.
1.Make sure the camera is turned off.
2.Open the
3.Gently slide the CF card into the card slot
4.Close card slot door.
5.To remove the CF card, open the card slot door and push the release
button located beside the card slot.
NOTE:
•For best operation, use only
•When installed, the Argus DC2250 saves captured images and movies directly to the CF card and bypasses its internal 6MB SDRAM memory.
•Changing the batteries will not erase the CF card memory.
6