6.Reinstall hydraulic suction hose and tighten hose clamp.

7.Lubricate rubber gasket on new oil filter with clean hydraulic oil.

8.Spin new oil filter onto filter housing until it makes contact. Tighten oil filter another 1/2 turn.

9.Add new oil to the oil tank.

10.Check hydraulic oil level.

11.Properly dispose of waste oil.

Purge Air From Hydraulic System

1.With the engine running, extend the hydraulic cylinder out fully and then retract fully.

2.Repeat 4 – 5 times. Erratic movement in the hydraulic cylinder indicates that there is air in the system.

3.Stop the engine and check the hydraulic oil level. Add if necessary.

4.Repeat extending and retracting of hydraulic cylinder unit motion is consistent and smooth in both directions.

5.Ensure that hydraulic oil is at proper level.

IMPORTANT: At this point a large amount of hydraulic oil has been drawn into the hydraulic cylinder and hoses. Be sure to refill the oil reservoir to prevent pump damage.

STORAGE

SHORT TERM

NEVER spray unit with high pressure water or store unit outdoors.

Inspect unit for visible signs of wear, breakage or damage.

Keep all nuts, bolts and screws properly tightened and know unit is in safe working condition.

Store unit in a cool, dry protected area.

Protect bare-metal areas with a light coat of oil or anti-rust compound.

LONG TERM

Perform all steps found in Short Term storage.

Touch up all scratched painted surfaces.

Remove weight from wheels by putting blocks under frame or axle.

Fuel System

Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system. These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container.

To treat the fuel system for storage:

1.Add fuel stabilizer (Ariens part number 00592900) according to manufacturer’s instructions.

2.Run engine for at least 10 minutes after adding stabilizer to allow it to reach the carburetor.

NEVER store the engine with fuel in the fuel tank inside of a building with potential sources of ignition.

To Take the Unit Out of Storage

1.Refer to the engine service manual to prepare the engine for service.

2.Put fresh, clean fuel in the fuel tank.

3.Begin the maintenance schedule.

EN - 20