Front Stand (Item 6)

4. Reinstall hair pin.

Front stand must be locked in the down position whenever the unit is in use and in the transport position when moving or towing the unit.

CAUTION: Front stand must be locked in the transport position before towing the unit.

(Figure 9)

1.Remove hair pin from clevis pin and remove clevis pin from tongue bracket.

2.Rotate stand up or down until the top edge of the handle on the stand aligns with the upper or lower notch in the tongue bracket.

3.Insert clevis pin into tongue bracket and insert hair pin.

Notch

Remove hair pin and clevis pin and rotate stand up or down.

Reinstall clevis pin and hair pin.

Figure 9

Rear Stabilizer (Item 12)

(Figure 10)

Rear stabilizer must be positioned down and locked in place when operating in the horizontal position.

1.Remove hair pin from upper lock pin and slide lock pin out from brackets.

2.Rotate rear stabilizer down until holes in stabilizer align with holes in brackets.

3.Insert lock pin all the way through brackets and stabilizer.

IMPORTANT: Rear stabilizer must be locked in the transport position before towing unit or before placing beam in vertical operating position.

Transport Position

Remove hair pin and slide lock pin out.

Work Position

Insert lock pin through brackets and insert hair pin.

Figure 10

OPERATION

FILLING FUEL TANK

To add fuel to the fuel tank:

1.Clean fuel caps and surrounding area to prevent dust, dirt, and debris from entering fuel tanks.

2.Remove fuel caps.

IMPORTANT: Refer to Engine Manual for correct type and grade of fuel.

3.Fill fuel tank to the bottom of filler neck. See SPECIFICATIONS on page 22 for fuel tank capacity.

EN - 14