Discharge Chute Control (921002, 003, 004)

IMPORTANT: If chute does not stay in set position, adjust as directed in SERVICE AND ADJUSTMENTS on page 21, or repair before operation.

Rotate the Chute with Discharge Chute Control.

921002, 003, 004

Figure 17

OS7105

 

IMPORTANT: DO NOT force frozen chute controls. If frozen, take to warm place until controls are free.

Discharge Chute Crank (921001)

IMPORTANT: If chute does not stay in set position, adjust as directed in SERVICE AND ADJUSTMENTS on page 21, or repair before operation.

Rotate the Chute with Discharge Chute Crank.

921001

Figure 18

OS7106

 

IMPORTANT: DO NOT force frozen chute controls. If frozen, take to warm place until controls are free.

Heated Handles (921003)
Remote Wheel Lock (921002)

Squeeze and release the remote wheel lock to lock the left wheel for better traction when throwing snow or to unlock the left wheel for easier steering.

NOTE: The wheel lock will not release when under load. Do not unlock the wheel while turning. If the wheel lock will not release, turn the unit slightly left or right to relieve axle load and release the axle lock.

If remote wheel lock does not lock or unlock properly, adjust or repair before operation (see Remote Wheel Lock (921002) on page 21).

Axle Lock Pin (921001)

(Figure 19)

Use the axle lock pin to lock or unlock the right or left wheel. Lock both wheels to increase traction; unlock one wheel to allow for easier turning of the unit.

NOTE: Unit will not drive with both wheels unlocked.

921001

Wheel Unlocked

Axle Lock Pin

Wheel Locked

Figure 19

OS6000

 

Scraper Blade

The scraper blade allows the back of the housing to keep better contact with the surface being cleared. It also prevents damage to the housing from normal wear.

1

Turn the heated handles switch to the ON (1) position to activate. Turn the switch to the OFF (2) position to

IMPORTANT: DO NOT allow Scraper Blade to wear too far or Auger/Impeller housing will become damaged.

2 deactivate.

OS1950

Runners

The runners control the distance between the scraper blade and the ground. Adjust runners equally to keep blade level with the ground. Refer to Pre-Starton page 16 for recommended settings.

GB - 15