NOTE: After the chute rod has been inserted through the hex hole in the control assembly, placing the unit in the service position (see Service Position on page 18) will ease alignment and installation of the hair pin.

8.Secure the chute rod to the control assembly with the hair pin removed in step 6. Insert the hair pin with the loop end to the left of the chute rod so the control assembly follows a full range of travel.

921002, 003, 004

3

2 4

1

1. Chute Rod

 

2. Gear Cover

 

3. Control Assembly

 

4. Hair Pin

 

Figure 9

OS7432

 

9.Insert the chute lock cable fitting into the bracket on the chute pedestal, and then connect the chute lock cable to the lock teeth by fitting the cable ball end into the slot on the lock teeth. See Figure 10.

NOTE: Press down on lock teeth with your finger to align the cable ball end with the slot (Figure 10).

Figure 10

OS7271

10. Replace the gear cover removed in step 4.

IMPORTANT: Rotate the discharge chute to the left when tightening the pedestal hardware to ensure clearance between the discharge chute and the belt cover.

11.Tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

12.Make sure the discharge chute rotates left and right when you push the discharge chute control lever left and right.

Install Discharge Chute and Discharge Chute Crank (921001)

(Figure 11)

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing.

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed in step 2.

NOTE: Leave discharge chute pedestal loose to help install the chute rod and connect it to the control assembly.

921001

4

1

3 2

1. Chute Rod

2. Gear Cover

3. Control Panel

4. Hair Pin

Figure 11

OS7061

 

4.Insert the short end of the chute rod into the hole in the front of the control panel.

5.Connect the chute crank to the pinion gear on chute with spring clip.

IMPORTANT: Rotate the discharge chute to the left when tightening the pedestal hardware to ensure clearance between the discharge chute and the belt cover.

6.Tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

Deflector Remote (921002, 003, 004)

Connect the cable end to the cable anchor on the discharge deflector before clipping the cable to the cable bracket on the discharge chute.

1.Route deflector remote cable along the left side of the chute pedestal.

GB - 9