SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust to the outdoor temperature before clearing snow.
NOTE: Attachment clutch should be engaged before wheel drive clutch when throwing snow.
1.Select Speed Control position and direction.
2.Engage Attachment Clutch - Right Hand Lever.
3.Engage Traction Drive Clutch - Left Hand Lever.
IMPORTANT: DO NOT overload unit capacity by attempting to clear snow at too fast a rate. Use slow speed to clear deep or hard packed snow.
Tips for Operation
Snow is best removed as soon as possible after snow fall.
To clear an area, run unit in an overlapping series of paths. For large areas, start in the middle and throw snow to each side, so snow is not cleared more than once.
ALWAYS direct snow away from area to be cleared and with direction of the wind.
TRAVELING
To travel from one work area to another:
1.Set Throttle to Slow or
2.921011, 012, 013, 017, 018, 019, 020: Press down on handlebars enough to raise front of unit slightly off surface.
921014, 015, 016: Place the unit in the transport position (see Track Angle on page 20).
3.Engage wheel or track drive clutch without engaging attachment drive clutch.
TRANSPORT
ALWAYS shut off engine, remove key, and close fuel
Use extra care when loading or unloading unit onto trailer or truck.
Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
MAINTENANCE
Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center.
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up onto housing, remove fuel so no spills will occur . Ensure unit is secure and will not tip over during maintenance.
1.Shut off engine, remove key, disconnect spark plug wire and allow unit to cool completely.
2.Close fuel
3.921019, 020: Drain fuel tank and fuel system (see Engine Manual for complete instructions).
4.Place unit on a flat level surface. Tip unit forward onto front of auger housing for service.
IMPORTANT: Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed.
Service Position
Figure 24 | OS7121 |
|
GB - 23