Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921032 quick start Step Four Install Discharge Chute Crank

Models: 921032

1 27

Download 27 pages 38.22 Kb

Page 8

Step Four: Install

Step Four: Install

Discharge Chute Crank

1.Remove the gear cover from top of chute pedestal.

2.Insert the short end of the chute crank into the hole in the front of the control panel.

NOTE: Be careful not to damage nylon bushing when attaching crank to the dash.

3.Connect the chute crank to the pinion gear on chute with hairpin.

4.Replace gear cover on top of chute pedestal.

5.Orient the chute and pedestal to its most vertical position and tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

Image 8

Ariens 921032 quick start Step Four Install Discharge Chute Crank

Contents

Quick Start Guide Deluxe 30 921032 s/n 101 & upStep One Assemble Handlebars Unfold Lower HandlebarAttach Upper Handlebar Assembly Step One Assemble HandlebarsAttach Control Cables Step One Assemble HandlebarsUnfold Upper Handlebar Step One Assemble HandlebarsStep Two Connect Headlight Wire Harness Step Three Install Discharge Chute Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Control Cable Step Six Install Skid Shoes SpacerStep Seven Check Function of Dual Handle InterlockStep Eight Check Tire Pressure Step Nine Check Auger Gearcase Oil Check oil level in auger gearcaseStep Ten Check Engine Crankcase Oil Ariens AX IMPORTANT The engineFILLING FUEL TANK in Fill fuel tank. DO NOT OVERFILL! SeeStep Twelve Fill Engine Fuel Tank Ariens AX Step Thirteen Starting the Engine Ariens AX Starting Engine / Step A Choke Turn throttle all the way up. Turn choke ONStarting Engine / Step B Rocker Switch Push rocker switch to RUN positionStarting Engine / Step C Fuel Shut Off Valve Turn fuel petcock to ON positionStarting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Press and hold starter buttonStarting Engine / Step H Warm up CHOKE OFF position2. Push rocker switch to STOP position 3. Pull safety key OUTStep Fourteen Stopping the Engine Ariens AX Under normal conditions 1. Turn throttle downPhone 2013 The Ariens Company. All rights reservedAdditional Resources Contact Ariens Company