GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before and after lubrication. Do not wipe gearcase filler plug; wiping the gearcase filler plug may remove thread sealant and cause leaks.
IMPORTANT: DO NOT allow grease or oil to get on friction disc, friction plate or belts.
NOTE: Apply Stens Mix
Auger Shaft
NOTE: To grease auger shaft, remove shear bolt nuts, and shear bolts. Turn auger on shaft while applying grease at zerk fittings. Replace shear bolts per instructions in SERVICE AND ADJUSTMENTS on page 22.
CLEAN BATTERY (926500, 501)
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
IMPORTANT: Battery is
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit before cleaning.
Remove corrosion from battery terminals and cable connections with a wire brush, then wash with a weak baking soda solution.
After cleaning, apply a thin coat of grease or petroleum jelly to terminals and cable ends to retard corrosion.
2
1 1 1 1
OS0642 | Grease | Oil |
OS7135 |
OS7140
OS7150 | Figure 18 |
|
GB - 21