1

2

1 2

3

 

3

4

4

 

 

5

 

5

1. Upper Position

4. Upper Mounting Bolt

2. Lower Position

5. Lower Mounting Bolt

3. Handlebar

 

Figure 21

OS7155

 

NOTE: Insert the hair pin with the loop end on the left side of the chute rod so the control lever will cover its full range of travel.

6.Align correct chute rod holes in chute control assembly as shown in Figure 22, and then secure chute rod in position with hair pin remove in step 1.

Upper Position Lower Position

 

1

1

 

 

2

 

2

 

 

33

1.Chute Control Assembly

2.Hair Pin

3.Chute Rod

Figure 22

OS7160

7.Check and adjust attachment clutch, speed selector and traction clutch. See Attachment Clutch/Brake Adjustment on page 25, Speed Selector Adjustment on page 25 and Traction Drive Clutch Adjustment on page 26.

8.Re-install bottom cover.

REMOTE DIFFERENTIAL (926004, 005, 006, 300, 301, 500, 501)

If remote differential does not lock:

1.Place unit in service position (see Service Position on page 19).

2.Remove bottom cover.

3.Loosen jam nuts on cable. Make sure the bottom jam nut is loosened enough to remove slack from cable.

4.Pull the cable adjuster to remove slack between the cable adjuster and the extension spring and hold the cable adjuster in position while tightening the top jam nut against the unit frame. Do not extend the spring or engage the mechanism.

5.Tighten the bottom jam nut.

6.Re-install bottom cover.

7.Check function of remote differential. If remote differential does not function properly, take unit to Dealer for repairs.

1

3

2

No Slack

1.Top Jam Nut

2.Bottom Jam Nut

3.Cable Adjuster

Figure 23

OS7165

REMOTE WHEEL LOCK (926002, 003, 102, 103, 302, 303, 304)

If remote wheel lock does not lock or unlock:

1.Place unit in service position (see Service Position on page 19).

2.Remove bottom cover.

3.Loosen jam nuts on cable. Make sure the bottom jam nut is loosened enough to remove slack from cable.

4.Pull the cable adjuster to remove slack between the cable adjuster and the extension spring and hold the cable adjuster in position while finger tightening the top jam nut against the unit frame. Do not extend the spring or engage the mechanism.

GB - 23