GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before and after lubrication.
IMPORTANT: DO NOT allow grease or oil to get on friction disc, friction plate or belts.
NOTE: Apply Stens Mix
Auger Shaft
NOTE: To grease auger shaft, remove shear bolt nuts, and shear bolts. Turn auger on shaft while applying grease at zerk fittings. Replace shear bolt per instructions in Service and Adjustments.
Grease Oil
OS1731
OS1374
Figure 11
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
DEFLECTOR REMOTE
Deflector must stay in selected position while throwing snow.
If deflector does not stay in set position:
1.Tighten nut beneath the control panel to increase friction on pressure flange (Figure 12).
If deflector does not follow full range of travel:
1.Push deflector remote all the way forward.
2.Loosen adjusting nuts on cable support bracket.
3.To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4.To adjust deflector higher: Slide cable up. Tighten top nut.
5.Check travel and repeat adjustment as necessary.
DISCHARGE CHUTE
If chute does not stay in position while operating, tighten nut on carriage bolt at pivot point to increase tension on spring (Figure 13).
Smooth and easy rotation of properly lubricated chute with crank is obtained by adjusting pinion and chute gear teeth so they mesh together.
GB - 19