2
1
1.Runner
2.Runner Hardware
Figure 14
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller housing will result if blade wears down too far.
Scraper blade is adjustable to compensate for wear.
To adjust scraper blade:
1.Tip unit back onto handlebar, support housing and loosen nuts retaining blade.
2.Adjust runners to fully raised position (housing closest to ground).
3.Reposition scraper blade flush with runners and tighten lock nuts.
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for replacement. Use of any other type of shear bolt may result in severe damage to unit.
Occasionally a foreign object may enter the auger/impeller housing and jam the auger, breaking shear bolts (Figure 15) which secure the auger to the shaft. This allows auger to turn freely on the shaft preventing damage to gear drive.
For Replacement:
1.Align shear bolt holes in auger with shear bolt holes in the shaft.
2.Drive shear bolt through hole (if shear bolt was broken this will drive remaining part from shaft).
3.Secure shear bolt with nut.
1 | OS6780 |
2
1.Auger
2.Shear Bolts
Figure 15
SPEED SELECTOR ADJUSTMENT
3
4
2
1
1.Shift Rod
2.Adjustment Pivot Pin
3.Speed Selector Lever
4.Hairpin
Figure 16
OSs0194
To adjust (Figure 16):
1.Remove hair pin from adjustment pivot pin.
2.Pull shift rod and adjustment pivot pin out of speed selector lever.
3.Place the speed selector in the fastest forward speed position.
4.Pull the shift rod straight down towards the ground as far as it will go.
GB - 21