Advanced Features
Programming Memory Buttons:
1 Select the section that you wish to program the Memory Button in by pressing the corresponding Device Button (AUD, or SAT) and MUTE button, simultaneously. SET will appear in the LCD.
2 Press one of the Memory Buttons (M1, M2, M3, M4, or POWER) into which you wish to store the functions.
3 Press in up to fifteen commands that you want stored in that Memory button. Each successive button selection will appear as
You can select functions from another mode by first pressing the corresponding Device Button and then the buttons where those functions are located in that mode. The pressing a Device Button also counts as one com- mand.
Note: Each insertion of a Device Button adds a 1/2 second delay to the command sequence.
4 Press the CHANNEL UP button to store your selections. SAVE will flash three times in the LCD to confirm the programming.
Note: It can take up to 15 seconds to send out 15 commands from a memory button. Please continue to point the remote control at the device(s) until all the commands on the Memory Button have been sent out. This will ensure that all the commands are received by the device(s).
Example: Memory Button Programming.
To program Memory Button M2 in the Audio mode to send the following commands: turn on the Audio receiver, turn on the TV, turn on the VCR, and turn on the satellite receiver.
24
