Using Your Remote

Note: SET appears in the LCD for 20 seconds to indicate that the remote control is ready to be programmed. The following steps must be entered while SET appears in the LCD.

4 Point the remote control toward the device that was turned on in Step 1 and press in the first three-digit Set- Up Code number for that device using the number buttons (0-9) on the remote control. SET followed by the number will appear in the LCD.

Your device will turn off when the correct Set-Up Code number has been selected. If the device does not turn off, press in the next Set-Up Code number from the listing. Continue to select Set-Up Code numbers until your device turns off, before you proceed to Step 5.

Note: If you have tried all of the three digit Set-Up Code numbers listed for your device and it still did not turn off, please proceed to the Auto Search Method on page (10) to program your remote control.

5 Once your device turns off, press the Device Button selected in Step 3 once again to store the Set-Up Code number. PASS will flash in the LCD.

6 Test the remote control for your device. Try the POWER, CHANNEL UP AND DOWN, VOLUME UP AND DOWN buttons, etc. If any of the buttons do not perform as they should, please repeat the set-up from Step 1 using the next Set-Up Code number for your device.

Note: Some audio/video devices have separate buttons for POWER ON and POWER OFF. To operate these devices on the remote, press the corresponding DEVICE Button to turn the equipment ON and press the POWER button to turn the equipment OFF.

7 Please repeat the above steps to program the remote control for each of your other devices.

9

Page 10
Image 10
Universal Remote Control SL-8000 manual Using Your Remote