3.Check oil level on dipstick. Oil level must be maintained at safe operating level. See SPECIFICATIONS on page 20. See Engine Manual for detailed information.
4.Replace cap.
To add oil:
1.Turn engine off and let cool for at least three minutes.
2.Remove cap from oil fill (Item 11) and add
3.Replace cap.
4.Clean up any spilled oil.
TRANSPORTING UNIT
1.Always shut off engine, remove key and close fuel
2.Use extra care when loading or unloading onto truck or trailer. Do not lift using discharge chute handle (Item 6).
3.Secure unit chassis to transport vehicle. Never secure from rods or linkages that could be damaged.
4.Do not transport unit while engine is running.
OPERATION
Start Engine (Recoil Start)
1.Check oil level. See Engine Oil on page 12.
2.Position discharge chute (Item 8) in a safe direction.
3.Move engine switch (Item 16) to ON position.
4.Open fuel
5.If engine is cold, turn choke (Item 15) to CLOSED position.
NOTICE: Do not apply choke to a warm engine.
6. Push primer bulb (Item 17) twice.
NOTICE: Do not push primer bulb to start a warm engine.
7.Slowly pull recoil starter handle (Item 5) until engine compression makes pulling difficult. Let starter rewind a little, and then pull smoothly and quickly to start engine.
8.Repeat step 7 as needed.
9.Gradually open choke after engine starts.
IMPORTANT: If engine does not start after three attempts, see TROUBLESHOOTING on page 19.
10.Pull auger control bar (Item 2) back to handlebar to start auger; release bar to stop auger.
Start Engine (Electric Start)
Models 938032, 033, 034
1.Check oil level. See Engine Oil on page 12.
2.Position discharge chute (Item 8) in a safe direction.
3.Connect a power cord to power cord recepticle (Item 19) and then plug cord into a wall outlet.
CAUTION: Use cord that is minimum of
13 amp, 16 Gauge, 3 wire grounded plug, UL listed, CSA Certified. Cord must be labeled suitable for outdoor use.
4.Move engine switch (Item 16) to ON position.
5.Open fuel
6.If engine is cold, turn choke (Item 15) to CLOSED position.
NOTICE: Do not apply choke to a warm engine.
7.Push primer bulb (Item 17) twice and then press electric start button (Item 18).
NOTICE: Do not push primer bulb to start a warm engine.
8.When engine starts, disconnect power cord from wall outlet, then disconnect cord from power cord recepticle.
IMPORTANT: If engine does not start after three attempts, see TROUBLESHOOTING on page 19.
9.Pull auger control bar (Item 2) back to handlebar to start auger; release bar to stop auger.
Discharge Chute (Item 8)
Models 938030, 031, 032, 034
IMPORTANT: Always throw snow in a safe direction, away from people and windows.
To control the discharge of snow:
1.Turn discharge chute handle (Item 6) in the direction you want to throw snow.
2.Loosen wing knob (Item 9) and move discharge chute deflector handle (Item 7) up or down to control snow throw height.
3.Tighten wing knob in desired position.
If chute becomes frozen and does not turn correctly, take unit into warm area until controls are unfrozen.
CAUTION: Do not use chute handle to lift the unit.
EN - 13