Figure 9

6.Position scraper assembly under housing. See Figure 10.

•D-shaped cutout must be on the left.

•Edge must point down and forward.

•Scraper assembly bolt holes must align with square bolt holes in auger housing.

1

1.Scraper Blade Edge Figure 10

7.Move scraper assembly backward and up until small lip on top of scraper blade contacts bottom lip of housing.

8.Install bolts and nuts. Tighten nuts to 40 – 50 in-lbf. Threads must protrude beyond the nut.

9.Return unit to operating position.

IMPORTANT: If auger paddles are pulling too strongly or scraper blade is not clearing completely, loosen nuts (do not remove) and slide scraper assembly down slightly. Tighten nuts.

Adjust Remote Chute Rotation

Cables

Model 938033

1.Move engine switch (Item 16) to OFF position and remove key. Allow unit to cool.

2.Open fuel and oil door (Item 22) to access chute rotation cable adjustment screws.

3.Loosen chute rotation cable adjustment screws. See Figure 11.

1

1.Chute Rotation Cable Adjustment Screws

Figure 11

4.Pull cable covers to the right to remove slack.

5.Tighten screws and close fuel and oil door.

IMPORTANT: Remote chute rotation cables may also be accessed from under unit by tipping unit forward.

FOR BEST PERFORMANCE

•For complete snow removal, walk slowly and slightly overlap each path previously taken.

•Position discharge chute downwind when possible.

•Do not pick up gravel and rocks. Push down slightly on handlebar to avoid picking up debris.

•Inspect auger before each use and remove any accumulation / debris.

•Check oil level before each use.

•Clean unit after each use.

EN - 16