Turn off engine when installing or removing block-off plate.

Do not overload the machine by attempting to chip or shred any material beyond manufacturer’s recommendation.

Do not vacuum large amounts of sand or gravel. These items are heavy and may cause unit to become unstable and tip.

Do not vacuum flammable liquids, such as gasoline, kerosene, diesel fuel, paint thinner, etc.

Do not vacuum burning or smoldering materials, such as cigars, cigarettes, ashes or cinders.

Do not vacuum airborne combustibles, dust from wood, paper, metal, glass, wire, etc.

Do not vacuum areas that have recently been treated with fertilizers, pesticides or herbicides. Follow the chemical manufacturer's safety instructions regarding contact with treated areas.

Do not operate on a paved, gravel or hard surface without collection bag attached. Discharged material may bounce from a hard surface.

Do not change the engine govenor settings or overspeed the engine.

Use extreme caution when reversing or pulling machine toward you. Always back up slowly and look down and behind before and while backing.

Do not tilt machine when starting engine.

Use only attachments and accessories approved by the manufacturer of the machine.

This product is equipped with an internal combustion type engine. Do not use unit on or near any unimproved, forest- or brush- covered land unless exhaust system is equipped with a spark arrester meeting applicable local, state or federal laws. A spark arrester, if used, must be maintained in effective working order by operator.

Never operate machine without good visibility or light.

Do not operate machine while under the influence of alcohol, drugs or medication. Safe operation requires complete and unimpaired attention at all times.

Before installing or removing collection bag, shut off engine and allow all moving parts to completely stop.

Empty collection bag after each use. Do not leave debris in bag while stored. Decomposed debris may generate enough heat to catch fire.

Slope Operation

Exercise extreme caution when operating on slopes. Do not attempt to operate on steep slopes.

Do not operate on slopes with greater than a 20° grade.

Avoid starting or stopping on a slope. Do not park unit on a slope unless absolutely necessary. When parking on a slope always block the wheels to prevent unit from rolling.

Do not operate near drop-offs, ditches, or embankments. Unit can suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.

Be prepared to react to an emergency when operating on slopes:

•Release drive control lever.

•Turn off engine.

Maintenance and Storage

Secure unit so it will not tip over during maintenance.

Before inspecting or servicing machine, shut off engine, disconnect wire from spark plug and allow moving parts to completely stop.

Allow hot parts to cool.

Keep machine, attachments and accessories in safe working condition.

Check engine-mounting bolts and other hardware at frequent intervals for proper tightness to be sure the equipment is in safe working condition. If components are worn or damaged, replace with manufacturer’s recommended parts.

Check discharge area frequently for wear and/or deterioration.

Adjust and service as required. All motion of drive wheels and moving parts must stop quickly when control levers are released.

Always maintain unit in safe operating condition. Damaged or worn out muffler can cause fire or explosion.

EN - 8