TROUBLESHOOTING
Problem | Probable Cause | Correction | |
|
|
| |
| Fuel tank empty. | Fill fuel tank with fuel. See Fuel Tank on page 13. | |
|
|
| |
| Throttle is in STOP | Move throttle control lever to desired position. | |
| position. | Use FAST to start a warm engine; use FULL | |
|
| CHOKE to start a cold engine. | |
Engine will not |
|
| |
Buildup of dirt and | Clean around govenor/carburetor. | ||
start. | residue around |
| |
| govenor/carburetor. |
| |
|
|
| |
| Interlock switch is not | Ensure collection bag is properly installed. See | |
| engaged. | Collection Bag on page 12 and Interlock Switch | |
|
| on page 13. See Dealer for repair. | |
|
|
| |
| Collection bag is full. | Shut off engine and empty bag. See Collection | |
Vacuum fails to |
| Bag on page 12. | |
|
| ||
Clog in vacuum inlet. | Shut off engine and check for clog in discharge | ||
pick up debris. | |||
|
| chute or vacuum inlet. See Clearing Clogs on | |
|
| ||
|
|
| |
| Polluted fuel supply. | ||
Engine runs |
| ||
|
| ||
Interlock switch is not | Ensure collection bag is properly installed. See | ||
briefly and stops. | |||
| engaged. | Collection Bag on page 12 and Interlock Switch | |
|
| on page 13. See Dealer for repair. | |
|
|
| |
| Drive control bar is not | Engage the drive control bar. See Drive Control | |
Vacuum will not | engaged. | ||
|
| ||
Drive belt is worn or | Replace belt. See Replacing Drive Belt on | ||
broken. | |||
equipped). | |||
|
| ||
| Drive belt cable is out of | Adjust cable. See Adjusting Drive Belt Tension on | |
| adjustment or broken. | ||
|
|
|
EN - 18