Ariston A1200WD, A1600WD, A1400WD Drainage connections, Electrical connections, First wash cycle

Installation

Drainage connections

		A. Connect the drain
	B	hose, without kinking it,
		to a draining duct or a
A
		wall drain fixed at a
		height between 65 and
		100cm from the floor.
		Use the curved bracket,
		if reqired.
		B. Alternatively, place
		it over the edge of a
		basin, sink or tub,
		fastening the hose
		supplied to the tap.

!The free end of the hose should not be under water.

!We advise against the use of hose extensions. In case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150cm in length.

Electrical connections

Before plugging the appliance into the mains socket, make sure that:

●the socket is earthed and in compliance with the applicable law.

●the socket is able to sustain the appliances maximum power load indicated in the Technical Details table (on the right).

●the supply voltage is included within the values indicated in the Technical Details table (on the right).

●the socket is compatible with the machines plug. If this is not the case, replace the socket or the plug.

!The machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

!When the machine is installed, the mains socket must be within easy reach and should be connected to a suitable electrical supply.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dan- gerously compressed.

!The power supply cable must only be replaced by an authorised serviceman.

!The company denies all liability if and when these norms are not respected.

The first wash cycle

GB

Once the appliance has been installed and before you use it for the first time, run a wash cycle without detergent and no laundry, setting the 90˚C programme without a pre-wash cycle.

Technical Details

Models	A1600WD, A1400SWD,
	A1400WD, A1200WD
	59.5cm wide
Dimensions	85cm high
	60cm deep
Capacity	from 1 to 6kg
Electric	voltage 220/240 Volts 50Hz
connections	maximum absorbed power:
	1700W-2100W
Water	maximum pressure 1 MPa (10 bar)
connections	minimum pressure 0.05 MPa (0.5 bar)
	drum capacity 53 litres
Spin Speed	up to 1600 rpm -	A1600WD
	up to 1400 rpm -	A1400SWD,
		A1400WD
	up to 1200 rpm -	A1200WD
Control	programme 3
programmes	temperature 60˚C
according to
IEC50229	- dry run with a 1kg load followed by
directive	a 5kg load for model A1600WD
	- dry run with a 2kg load followed by
	a 4kg load for models A1400SWD,
	A1400WD and A1200WD

This appliance is compliant with the following European Community Directives:

- 72/23/CEE of 19/02/73

(Low Voltage) and subsequent amendments.

-89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments.

3