Installation
Drainage connections
A. Connect the drain hose, without kinking it, to a draining duct or a wall drain fixed at a height between 65 and 100cm from the floor.
B. Alternatively, place it over the edge of a basin, sink or tub, fastening the hose supplied to the tap. The free end of the hose should not be under water.
!Do not use extensions or multiple sockets.
!The power supply cable must never be bent or dangerously compressed.
!The power supply cable must only be replaced by an authorised serviceman.
WARNING! The company denies all liability if and when these norms are not respected.
B
A
!We advise against the use of hose extensions. In case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket, make sure that:
●the socket is earthed and in compliance with the applicable law.
●the socket is able to sustain the appliances maximum power load indicated in the Technical Details table (on the right).
●the supply voltage is included within the values indicated in the Technical Details table (on the right).
●the socket is compatible with the washing machines plug. If this is not the case, replace the socket or the plug.
!The washing machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.
!When the washing machine is installed, the mains socket must be within easy reach and should be connected to a suitable electrical supply.
The first wash cycle
Once the appliance has been installed and before you use it for the first time, run a wash cycle without detergent and no laundry, setting the 90˚C programme without a
Technical Details
Models | A1636S, A1636, A1436 and A1235 |
|
|
| 59.5cm wide |
Dimensions | 85cm high |
| 60cm deep |
|
|
Capacity | from 1 to 6kg |
|
|
Electric | voltage 220/230 Volts 50Hz |
connections | maximum absorbed power 1700W |
|
|
Water | maximum pressure 1 MPa (10 bar) |
connections | minimum pressure 0.05 MPa (0.5 bar) |
| drum capacity 53 litres |
|
|
Spin Speed | up to 1600 rpm - A1636S & A1636 |
| up to 1400 rpm - A1436 |
| up to 1200 rpm - A1235 |
|
|
Control | programme 3 |
programmes | temperature 60˚C |
according to run with a load of 6 kg
IEC456 directive
This appliance is compliant with the following European Community Directives:
-72/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments.
-89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments.
3
