Ariston A1637, A1237, A1437 manual Drainage connections, Electrical connections, First wash cycle

Installation

Drainage connections

A. Connect the drain hose,

Bwithout kinking it, to a

	draining duct or a wall
A
	drain fixed at a height
	between 65 and 100cm
	from the floor.
	B. Alternatively, place it
	over the edge of a basin,
	sink or tub, fastening the
	hose supplied to the tap.
	The free end of the hose
	should not be under
	water.

!We advise against the use of hose extensions. In case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150cm in length.

Electrical connections

Before plugging the appliance into the mains socket, make sure that:

●The socket is earthed and in compliance with the applicable law.

●The socket is able to sustain the appliances maximum power load indicated in the Technical Details table (on the right).

●The supply voltage is included within the values indicated in the Technical Details table (on the right).

●The socket is compatible with the machines plug. If this is not the case, replace the socket or the plug.

!The machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

!When the machine is installed, the mains socket must be within easy reach and should be connected to a suitable electrical supply.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dangerously compressed.

!The power supply cable must only be replaced by an authorised serviceman.

!The company denies all liability if and when these norms are not respected.

The first wash cycle

GB

Once the appliance has been installed and before you use it for the first time, run a wash cycle without detergent and no laundry, setting the 90˚C programme without a pre-wash cycle.

Technical Details

Models	A1637
	A1437
	A1237
	59.5cm wide
Dimensions	85cm high
	60cm deep
Capacity	from 1 to 7kg Wash
Electric	voltage 220/240 Volts 50Hz
connections	maximum absorbed power:
	1700W-2100W
Water	maximum pressure 1 MPa (10 bar)
connections	minimum pressure 0.05 MPa (0.5 bar)
	drum capacity 54 litres
Spin Speed	up to 1600 rpm -	A1637
	up to 1400 rpm -	A1437
	up to 1200 rpm -	A1237
Control	programme 3
programmes	temperature 60˚C
according to	- run with a 7kg load
IEC456
directive

This appliance is compliant with the following European Community Directives:

- 73/23/EEC & 93/68/EEC

(Low Voltage) and subsequent amendments.

-89/336/EEC,92/31/EEC & 93/68/EEC (Electromagnetic Compatibility) and subsequent amendments.

3