Ariston AFA 370 manual Starting the dishwasher, Ready, steady, go, D Ishwasher, cancel, Make, sure

D ISHWASHER

Starting the dishwasher

Ready, steady, go!

You have loaded your dishes and you now have to set the wash cycle. It takes just one minute to learn how

First of all.

Afterperformingalltheoperations described in the previous paragraphs,turnthewatertapon completely and press ON-OFF button "A": you will hear a short beepandindicatorlight"B"lights up. Now the appliance is on and readytobeprogrammed.

Selecting the wash cycle.

Toselectthewashcycle,turnknob "D"clockwiseuntilthereference notch on the knob corresponds withthenumberorsymbolforthe cycleyouwishtoset(havealook at the wash cycle table on page 6). Ashortbeepwillindicatethe start of the wash cycle and indicatorlight"G"corresponding tothecyclestartingphasewilllight up.

The dishwasher keeps you informed.

Your dishwasher is fitted with indicatorlights(G)whichlightup toindicatethecyclephaseunder way.

Herearethesymbolscorrespond- ingtoeachcyclephase: pre-wash,wash,rinses,drying.

Atalltimes,yourdishwashertells you which cycle phase is under way.

Modifying a wash cycle in progress.

Butifyouhavechosenthewrong cycle,nottoworry!Youcanmodify thewashcycleinprogress,ifithas only just started. Turn the knob anti-clockwiseuntilitreachesthe Reset position and, after a few seconds, you will hear 4 beeps and indicator light "G" will turn off. This is to inform you that all the settings have been can- celled. You are now free to re- set the correct wash cycle.

You've left out a dish?

Well, it happens to everyone. Interrupt the wash cycle by pressing the ON-OFF button, insert the dish you had forgot- ten and press the ON-OFF but- ton again. The cycle will start up from where you interrupted it.

Finished?

The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light.

Turn the knob anti-clockwise to Reset in order to reset all the settings.

Warning:

Turn the appliance off by pressingbutton“A”,unplug the appliance from the electricity socket to cut off thepowersupply;thepower supply cable should consequently be easily accessible.

Turnoffthewatertap.

Waitafewminutesbeforeunload- ingthedishes:theyareveryhot!If you wait a little while, they dry betterthankstothesteam.

Emptythelowerrackfirst.

There's been a power failure? Have you opened the dishwasher door?

The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. Everything is under control!

If opening the door soon after the end of the programme,or during it, stand away from the Dishwasher, to

You	can	cancel	Make	sure	the
the	wash	cycle	wash	cycle	has
in progress, if it			ended before
has	only just		removing		the
started.			dishes!

avoid possible

injury from hot

steam .

4ARISTON DISHWASHER - Instructions for installation and use