Ariston ASL70C manual Maintenance and Care

Maintenance and Care

GB	Switching off the electricity				Cleaning the drum
	! Unplug your dryer when not using it, when cleaning				! Do not use abrasives, steel wool or stainless steel
	it and during all maintenance operations.				cleaning agents to clean the drum.
	Clean the filter after each cycle				A coloured film may start to appear on the stainless
					steel drum, this may be caused by a combination of
					water and, or cleaning agents such as fabric conditioner
	The filter is an important part of your dryer:				from the wash. This coloured film will not affect the
	it accumulates lint and fluff that is formed while drying.				dryer performance.
	When finished drying, clean the filter by rinsing it
	under running water or with your vacuum cleaner.				Cleaning the condenser unit
	Should the filter become clogged up, the airflow inside
	the dryer will be seriously compromised: drying times
	lengthen and you will consume more energy. It may				Periodically (every month) remove the condenser unit
	also damage your dryer.				and clean any build up of fluff from between the plates
					by rinsing it under the tap with cold water.
	The filter is found in front of the dryer trim (see diagram).				This should be done with cold water from the rear of
	Removing the filter:				the condenser.
	1. Pull the plastic grip of the filter upwards (see diagram).				Removing the condenser:
	2. Clean the filter and replace it correctly.				1. Unplug the dryer and open the door.
	Ensure the filter is fully located flush into the tumble				2. Pull open the condenser cover (see diagram).
	dryer trim.					Release the three catches by turning 90˚ counter-
	! Do not use the dryer without replacing the filter.					clockwise then pull on the grip and remove from
						the dryer.
	Empty the water container after each				3. Clean the surface of the seals and replace, making
						sure that the catches have been secured.
	cycle
	Pull the container out of the dryer and empty it into a				Cleaning the dryer
	sink or other suitable drain.
	Replace the water container securely.				●	External parts in metal or plastic and rubber parts
	Always check and empty the container before you					can be cleaned with a damp cloth.
	start a new drying programme.				●	Periodically (every 6 months) vacuum the front air
						intake grille and vents at the rear of the dryer, to
	Check the drum after each cycle					remove any build up of fluff, lint or dust. Also to
						remove accumulation of fluff from the front of the
						condenser and filter areas, clean occasionally with
	Turn the drum manually in order to remove small items					a vacuum cleaner.
	(handkerchiefs) that could have been left behind.				! Do not use solvents or abrasives.
					! Your dryer uses special bearing components which
					do not need lubrication.
	Water container			Filter	! Have your dryer checked regularly by authorised
					technicians to ensure electrical and mechanical safety
					(see Service).
								Tap
										Rear
	Condenser cover			Air intake					Front
							Condenser unit
		Catches	Handle

10