Ariston AVTL 104 manual First wash cycle, Technical details

Connecting the drain hose

￿ When the washing machine is installed, the main

socket must be within easy reach.

GB

65 - 100 cm

Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor;

￿ Do not use extensions or multiple sockets.

￿ The power supply cable must never be bent or

dangerously compressed.

￿ The power supply cable must only be replaced by

an authorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.

Installation Description

alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

￿We advise against the use of hose extensions; in case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electric connection

Before plugging the appliance into the mains socket, make sure that:

•the socket is earthed and in compliance with the applicable law;

•the socket is able to sustain the appliance's maximum power load indicated in the Technical details table (on the right);

•the supply voltage is included within the values i ndicated on the Technical details table

(on the right);

•the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug.

￿The washing machine should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, setting the 90°C programme without a pre-wash cycle.

Technical details

Model	AVTL 104
	40 cm wide
Dimensions	85 cm high
	60 cm deep
Capacity	from 1 to 5 kg
Electric	voltage 220/230 Volts 50 Hz
connections	maximum absorbed power 1850 W
Water	maximum pressure 1 MPa (10 bar)
	minimum pressure 0.05 MPa (0.5 bar)
connections
	drum capacity 42 litres
Spin speed	up to 1000 rpm
Control
programmes	programme 3; temperature 60°C;
according to	run with a load of 5 kg.
IEC456 directive

This appliance is compliant with the following European Community Directives:

-73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments

-89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments

-2002/96/CE

Programmes Detergents Precautions

Care Troubleshooting Service

3