Starting the dishwasher
Ready, steady, go!
You have loaded your dishes and you now have to set the wash cycle. It takes just one minute to learn how
After performing all the operations described in the previous paragraphs, if accessible turn the water tap on, open the appliance door and press
Your appliance is now on and awaiting instructions.
Selecting the wash cycle.
Select the wash cycle by pressing button "P". Each time this button is pressed, one of the indicator lights "M" will come on in sequence, select the wash cycle you deem most suitable for the type of dishes to wash (take a look at page 7, where you will find the wash cycle table). Close the appliance door and after a few seconds, you will hear a short beep: the wash cycle has begun.
utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it.
Finished?
The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "M". Open the dishwasher door, press the
If accessible turn off the water tap.
Wait a few minutes before unloading the dishes: they are very hot! If you wait a little while, they dry better thanks to the steam.
Empty the lower rack first.
You decide when it starts.
When you have loaded the dishes, you can choose when to start your dishwasher before setting the desired wash cycle. Press button "C" to delay the start of the wash cycle by 2, 4 or 6 hours. Each
You want to wash on the upper rack only? Remember to use half the amount of detergent.
Your dishwasher also allows you to wash half a load, to save water and electricity.
Before setting any wash cycle whatsoever, press
Modifying a wash cycle in progress.
If you have chosen the wrong cycle, not to worry! You can modify the wash cycle in progress, if it has only just started. Open the appliance door carefully to avoid any hot water splashes, then keep button "P" pressed for approximately 5 seconds, until you hear a short beep. Indicator light "M" will come off and at this point, all the settings will have been cancelled. You are now free to
You've left out a dish?
Well, it happens to everyone. Interrupt the wash cycle by opening the appliance door with the
You can cancel the
wash cycle in progress, if it has only just started.
If opening the door soon
after the end
of the program, or
during it, stand away from the Dishwasher, to avoid possible injury from hot steam.
There's been a power failure? Have you opened the dishwasher door?
The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. Everything is under control!
Do you want extra drying?
Press button "E" before you start the selected wash cycle. A long beep will tell you that you have selected extra drying and the wash cycle will last longer in order to provide you with drier dishes.
time you press it, you will hear a short beep and indicator light "D" corresponding to the selected delay will come on.
Now you can select the desired wash cycle. Close the appliance door and, after you hear the beep, the countdown to the delayed start will begin.
Once this time is up, the indicator light will stop flashing and the wash cycle will begin.
If you change your mind and you wish to set a different delay, just open the appliance door, press button "C" and repeat the selection.
If, on the other hand, you want to cancel the delayed start set and you want the wash cycle to start immediately, press the button repeatedly until indicator light "D" comes off. Once you close the door, the wash cycle set previously will begin.
button “Q” to select that you want to run a half cycle on the upper rack.
When you press it, you will hear a beep and indicator light “R” corresponding to the selected function will come on.
Make sure the wash
cycle has ended before
removing the dishes!
www.aristonappliances.us | ARISTON DISHWASHER - User Manual 5 |