Ariston OS 99D P IX manual Electrical connection

Electrical connection

￿Ovens equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover

(see diagram).

2. Install the power supply cable by

	loosening the cable
L	clamp screw and the
	three wire contact
	screws L-N- .
	Connect the wires to
	the corresponding
	terminals: the Blue wire
	to the terminal marked
	(N), the Brown wire to
N	the terminal marked (L)
	and the Yellow/Green
	wire to the terminal

marked (see diagram).

3.Secure the cable by fastening the clamp screw.

4.Close the cover of the terminal board.

Connecting the electricity supply cable to the mains

Install a standardised plug corresponding to the load indicated on the data plate (see table).

The appliance must be directly connected to the mains using an omnipolar switch with a minimum contact opening of 3 mm installed between the appliance and the mains. The switch must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the switch). The supply cable must be positioned so that it does not come into contact with temperatures higher than 50°C at any point.

￿The installer must ensure that the correct electrical connection has been made and that it is fully compliant with safety regulations.

Before connecting the appliance to the power supply, make sure that:

•The appliance is earthed and the plug is compliant with the law.

• The socket can withstand the maximum power of	GB
the appliance, which is indicated on the data
plate (see below).

•The voltage is in the range between the values indicated on the data plate (see below).

•The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Do not use extension cords or multiple sockets.

￿Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.

￿The cable must not be bent or compressed.

￿The cable must be checked regularly and replaced by authorised technicians only (see Assistance).

￿￿ The manufacturer declines any liability should these safety measures not be observed.

APPLIANCE SPECIFICATIONS

Dimensions	width 43.4 cm
	height 39.5 cm
	depth 40.8 cm
Volume	70 l
Electrical	voltage: 220 - 240 V~ 50Hz
	maximum power absorbed
connections
	3400 W (see data plate)
	Directive 2002/40/EC on the
	label of electric ovens.
ENERGY	Standard EN 50304
	Declared energy consumption
LABEL
	for Forced convection Class –
	heating mode:
	Gratin.
	This appliance conforms to the
	following European Economic
	Community directives:
	2006/95/EEC dated 12/12/06
	(Low Voltage) and subsequent
	amendments – 2004/108/EEC
	dated 15/12/04
	(Electromagnetic Compatibility)
	and subsequent amendments -
	93/68/EEC dated 22/07/93 and
	subsequent amendments.
	2002/96/EEC and subsequent
	amendments.
	1275/2008 stand-by/off mode.

3