Front
Hooking position | Back |
for top H=40 mm |
|
!Use the hooks contained in the “accessory pack”
•Where the hob is not installed over a
Ventilation
To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams).
. | 45 | mm | . |
mm |
| ||
560 |
|
|
|
When installing the cooktop above a
Electrical connection
Hobs equipped with a
Connecting the supply cable to the mains |
| |
GB | ||
Fit the supply cord with a standard plug for the | ||
demand rate indicated on the rating plate or connect |
| |
| ||
it directly to the electrical mains. In the latter case, a |
| |
single pole switch must be placed between the |
| |
appliance and the mains, with a minimum opening |
| |
between the contacts of 3 mm in compliance with |
| |
current safety codes (the earthing wire must not be |
| |
interrupted by the switch). The power supply cord |
| |
must be positioned so that it does not reach a |
| |
temperature in excess of 50°C above room |
| |
temperature at any point. |
| |
Before making the actual connection, make sure |
| |
that: |
|
•The fuse and electrical system can withstand the load required by the appliance;
•That the electrical supply system is equiped with an efficient earth
•That the plug or switch is easily accessible.
!the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow | - | Earth |
Blue | - | Neutral |
Brown | - | Live |
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
Connect the Green & Yellow wire to the terminal
marked “E” or | or coloured Green or Green & |
Yellow. |
|
Connect the Brown wire to the terminal marked “L” or coloured Red.
Connect the Blue wire to the terminal marked “N” or coloured Black.
!Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.
!The cable must not be bent or compressed.
!The cable must be checked regularly and replaced by authorised technicians only (see Assistance).
!The manufacturer declines any liability should these safety measures not be observed.
Gas connection
The appliance should be connected to the main gas supply or to a gas cylinder in compliance with current national regulations. Before carrying out the connection, make sure the cooker is compatible with the gas supply you wish to use. If this is not the case, follow the instructions indicated in the paragraph “Adapting to different types of gas.”
When using liquid gas from a cylinder, install a pressure regulator which complies with current national regulations.
3