4. Setup
Attaching the WZE-3 to the ZMU-3
Plug the WZE-3 onto the ZMU-3 and secure the connection using the ZMU-3 bracket D photo.
K4.65860.0 ZMU-3 Bracket assy.
Slide the bracket over the ZMU-3 rosette, rotate it, until the lug hides under the WZE-3‘s knurled screw. Fasten the bracket on the WZE-3 and use a 3mm hex wrench to secure the bracket on the ZMU-3‘s rosette edge.
Selecting the radio channel
The radio modem in the WZE-3 utilises a specific scheme of constantly changing frequencies, making the connection between the different radio units very robust against interference. The even channels on the radio channel selector switch (numbers 0, 2, 4, 6) utilize the upper half of the bandwidth (2444 - 2472 MHz) while the odd numbers (1, 3, 5, 7) use the lower frequencies (2406 - 2435 MHz).
To establish a connection between one or more Wireless Main Units (a maximum of three per radio channel is possible), the WZE-3 must be set to the same radio channel as the receiving URM-2/-3, UMC-3, LDB-2 or ARRIFLEX 416 plus (HS).
It is not possible to control two receiving units with one WZE-3.
Note: | In case two remote systems with the "-2" or "-3" |
| series modems (yellow antenna washer) are |
| on the same set, it is recommended to set one |
| of the systems to an upper (even) channel and |
| one system to a lower (odd) channel number. |