ASA Electronics Universal Remote Basic Operations, Power TBXPAL On, Set TV source to A/V input

Basic Operations

1. Power TBXPAL On

1-1 Feed the “+12VDC” power supply to TBXPAL’s “POWER INPUT” socket.

2.Set TV source to A/V input

3.Scan Channels and Auto-programming

3-1Press the [ A /P ] button on the remote.

Tuner will scan all channels in the “AIR” and “CATV” modes and memorize channels with PAL TV signal in the modes for “AIR” and “CATV”.

It takes 45 and 75 seconds to scan in the “AIR” and “CATV” modes respectively.

4.Adjust the volume of Audio Output

4-1Press the [ VOL + ] button to increase the audio volume. 4-2Press the [ VOL - ] button to decrease the audio volume.

5.Adjust the TBXPAL’s System Settings

Press [ MENU ] button to activate the setting menu.

5-1The 1st menu item is “TUNER MODE”. Press [ ► ] or [ ◄ ] to browse and select a tuner mode from “AIR” and “CATV”.

5-2Press [ MENU ] 2nd time. The 2nd menu item is “AUDIO OUTPUT”.

Press [ ► ] or [ ◄ ] to browse and select an option from “STEREO”, “MAIN”, “SUB” or “MONO” depending on the audio signals available in the TV signal.

5-3Press [ MENU ] 3rd time. The 3rd menu item is “CHANNEL SKIP”. Press [ ► ] or [ ◄ ] to turn the skip mode “ON” or “OFF”.

When skip mode is “ON”, pressing [ CH+ ] or [ CH- ] will go to next or previous broadcasted channel.

When skip mode is “OFF”, pressing [ CH+ ] or [ CH- ] will increase or decrease the channel by one.

5-4Press [ MENU ] 4th time. The 4th menu item is “RESET”.

Press [ ► ] or [ ◄ ] to restore the factory’s default value for above settings, and remove programmed channels with PAL TV signal for “AIR” and “CATV” modes.

All settings are saved to non-volatile memory when OSD disappears. ( Approximate 6 seconds for storage)

6.Searching a channel and Watching

6-1Press [ CH+ ] or [ CH- ].

6-2Directly Input a channel number by pressing [ 0 ] ~ [ 9 ] buttons.

3