| TECHNICAL NOTES & SPECIFICATIONS |
|
|
ARCHITECTS SPECIFICATIONS
| LED shall indicate excessive temperature. The power output devices shall |
The power amplifier, being of two channels, shall deliver a minimum | be complementary bipolar transistors. |
power of 750 watts RMS per channel into 8 ohm loads and 1200 watts | The amplifier shall weigh 61 lbs net and mount in a standard 19 inch rack |
RMS per channel into 4 ohm loads, or 1500 watts per channel into 2 ohm | |
loads with both channels operating. When switched into | using three spaces (5.25 high). The power requirement shall be 110- |
mode, the amplifier it shall deliver at least 2400 watts into an 8 ohm load. | 125VAC, |
The amplifier shall be immune to damage from shorted, open, or mis- |
|
matched loads. The amplifier shall have a gain of 38 dB per channel and |
|
an input sensitivity of 1 Volt RMS for full rated output. Frequency |
|
response shall be 20Hz to 20kHz |
|
including pure capacitors and inductors. Hum and noise shall be at least |
|
105dB below full output and total harmonic distortion shall be less than |
|
.025% below 1KHz. The amplifier shall have rear panel switching for paral- |
|
lel mono and bridging modes and rear mounted level controls. The inputs |
|
shall be of balanced bridging type with female XLR connectors as well as |
|
1/4 phone jacks and barrier strips. A |
|
be employed to show the power level of each channel and two speed forced |
|
air cooling shall be used. Each channel shall have a PROTECT LED which |
|
indicates an open relay due to |
|
delay. A LIMIT LED shall indicate any limiting action and a THERMAL |
|
|
|
Features:
Bipolar Output Devices
Modular Construction
XLR, 1/4", and Barrier Strip inputs
Stereo, Parallel Mono & Bridging Modes
LED Level meters and Status LEDs
Stable Into Any Load
Self Protecting Under Virtually All Conditions
Input Transformers Optionally Available
PowerCard Input Option Ready
Speakon and Binding Post Outputs
