Asko T741C important safety instructions Program Memory, Changing Option Settings, Error Messages

SIGNAL

Press this button to set a signal to sound for three seconds when a program is complete. The indicator light will stay lit when this option is on.

If you selected the Wrinkle-free option, the signal will sound every time the drum rotates.

PROGRAM MEMORY

The dryer is designed to retain the settings last selected with each program. For example, if you select Normal, the Low temperature option, a 2-hour anti-crease, and Quick cool-down, next time you select Normal these options will automatically be selected.

QUICK COOL-DOWN

Every program, except Air Fluff, ends with a cool-down cycle that tumbles the clothes without heat to reduce wrinkling. The Cool-down button lets you choose between the Normal cool-down cycle (15 minutes) or a Quick cool-down cycle (5 minutes). The indicator light will stay lit when Quick is selected.

CHANGING OPTION SETTINGS

You cannot change the option settings after you have pressed Start. To change a setting, hold down the Stop button until the unit stops, make your change, then press Start again. The program will restart from the beginning.

CHILD-SAFE START FEATURE

You can program the dryer not to start unless the Start button is held down for three seconds. This is to prevent children from inadvertently starting the machine. To program this function, follow the steps below:

1.Turn the machine off then on again. (“00” should show on the LED.)

2.Press the Start button five times in succession then press the Wrinkle-free button five times. (This must be done within 15 seconds.)

3.Within three seconds, press the Wrinkle-free button again to select Child-safe start. The LED will display “3” to indicate the Child-safe start is active. (If the child-safe start has already been activated, “0” will display after you press the Wrinkle-free button.)

ERROR MESSAGES

Error messages will display on the LED if a fault occurs while a program is in progress. The table below defines each possible error message. If the message still

displays after you have checked the possible solutions, call a service technician.

MESSAGE	ERROR
F1	Call a service technician.
F2	There may have been a power outage. Check the breaker box and fuses.
	The dryer is programmed to stop after a maximum of 3 hours drying time. If it has run this long,
	let it cool and try to start the program again.
	Try turning the power off then on again. If the message remains, call a service technician.
F3	This indicates a thermistor fault. Call a service technician.
F4	This indicates the overheat protection device has activated. Clean the lint filter and try running
	the program again.
F5	This indicates a fault in the moisture sensor. Running a dry program with dry clothes or an
	empty machine could also cause this error. Try opening the door. If the message remains, call a
	service technician.

Page 13