ASRock E350M1/USB3 manual Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

Serial ATA3 Connectors

(SATA3_1: see p.2, No. 12)

(SATA3_2: see p.2, No. 10)

(SATA3_3: see p.2, No. 11)

(SATA3_4: see p.2, No. 9)

Serial ATA (SATA) Data Cable

(Optional)

SATA3 2	SATA3 4
SATA3 1	SATA3 3

These four Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate.

Either end of the SATA data cable can be connected to the SATA / SATAII / SATA3 hard disk or the SATAII / SATA3 connector on this motherboard.

USB 2.0 Headers							Besides four default USB 2.0
(9-pin USB6_7)							ports on the I/O panel, there
(see p.2 No. 19)							are two USB 2.0 headers on
							this motherboard. Each
							USB 2.0 header can support
							two USB 2.0 ports.
(9-pin USB8_9)		USB_PWR
(see p.2 No. 18)			P-9
				P+9
					GND
	1					DUMMY
					GND
				P+8
			P-8
		USB_PWR
Consumer Infrared Module Header							This header can be used to
(4-pin CIR1)							connect the remote controller
(see p.2 No. 17)							receiver. Please refer to p. 144
							for details.

English

Front Panel Audio Header	GND
(9-pin HD_AUDIO1)		PRESENCE#
			MIC_RET
				OUT_RET
(see p.2 No. 20)

1

OUT2_L

J_SENSE

OUT2_R

MIC2_R MIC2_L

This is an interface for front panel audio cable that allows convenient connection and control of audio devices.

17

ASRock E350M1/USB3 Motherboard