ASRock H61M-DP3 manual Onboard Headers and Connectors

2.10 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

Serial ATA2 Connectors

(SATA_0: see	p.13, No. 13)	SATA_3	SATA_1
(SATA_1: see	p.13, No. 11)
(SATA_2: see	p.13, No. 14)
(SATA_3: see p.13, No. 10)		SATA_2	SATA_0

These four Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate.

Serial ATA (SATA)	Either end of the SATA data
Data Cable	cable can be connected to the
(Optional)	SATA2 hard disk or the SATA2
	connector on this motherboard.
USB 2.0 Headers	Besides four default USB 2.0
(9-pin USB4_5)	ports on the I/O panel, there
(see p.13 No. 16)	are two USB 2.0 headers on
	this motherboard. Each
	USB 2.0 header can support
	two USB 2.0 ports.
(9-pin USB6_7)
(see p.13 No. 15)

Consumer Infrared Module Header	This header can be used to
(4-pin CIR1)	connect the remote
(see p.13 No. 17)	controller receiver.

27