after you update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clear-CMOS action.

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

Primary IDE connector (Blue)

(39-pin IDE1, see p.11 No. 6)

 

PIN1

IDE1

 

 

connect the blue end

 

connect the black end

to the motherboard

 

to the IDE devices

80-conductor ATA 66/100/133 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

(SATAII_1 (PORT 0.0): see p.11,No. 12) (SATAII_2 (PORT 0.1): see p.11, No. 9) (SATAII_3 (PORT 1.0): see p.11,No. 11) (SATAII_4 (PORT 1.1): see p.11,No. 10)

Serial ATA (SATA) Data Cable

(Optional)

SATAII 2

(PORT 0.1)

SATAII 4

(PORT 1.1)

SATAII 1

(PORT 0.0)

SATAII 3

(PORT 1.0)

These four Serial ATAII (SATAII) connectors support SATAII or SATA hard disk for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.

Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on the motherboard.

20