Multiplier/Voltage Change

This item is set to [Auto] by default. If it is set to [Manual], you may adjust the value of Processor Frequency and Processor Voltage. However, it is recommended to keep the default value for system stability.

BIOS SETUP UTILITY

Main OC Tweaker Advanced H/W Monitor Boot Security Exit

CPU Configuration

Overclock Mode

[Auto]

CPU Frequency (MHz)

[200]

PCIE Frequency (MHz)

[100]

Boot Failure Guard

[Enabled]

Boot Failure Guard Count

[3]

CPU/LDT Spread Spectrum

[Enabled]

PCIE Spread Spectrum

[Enabled]

SATA Spread Spectrum

[Enabled]

ASRock UCC

[Disabled]

AMD Turbo Core Technology

[Auto]

AMD IO C-State Support

[Enabled]

CPU Active Core Control

[Disabled]

Processor Maximum Frequency

x16.5 3300 MHZ

North Bridge Maximum Frequency

x10.0 2000 MHZ

Processor Maximum Voltage

1.43750 V

Multiplier/Voltage Change

[Manual]

Overclocking may cause damage to your CPU and motherboard.

It should be done at your own risk and expense.

Select Screen

Select Item

Enter Go to Sub Screen

F1 General Help

F9 Load Defaults

F10 Save and Exit

ESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

CPU Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

Processor Voltage

It allows you to adjust the value of processor voltage. However, for safety and system stability, it is not recommended to adjust the value of this item.

NB Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

HT Bus Speed

This feature allows you selecting Hyper-Transport bus speed. Configuration options: [Auto], [x1 200 MHz] to [x5 1000 MHz].

HT Bus Width

This feature allows you selecting Hyper-Transport bus width. Configuration options: [Auto], [8 Bit] and [16 Bit].

Memory Configuration

Memory Clock

This item can be set by the code using [Auto]. You can set one of the standard values as listed: [400MHz DDR3_800], [533MHz DDR3_1066], [667MHz DDR3_1333] and [800MHz DDR3_1600].

DRAM Voltage

Use this to select DRAM voltage. The default value is [Auto].

34