Asus 810E2 MICROATX MOTHERBOARD 3.5System Memory (DIMM), 3.5.1 General DIMM Notes, NOTE:, 3.3Volt, Chip Configuration, ASUS TUWE-MUser’s Manual, Install memory in any combination as follows:

3.HARDWARE SETUP

3.5System Memory (DIMM)

NOTE: No hardware or BIOS setup is required after adding or removing memory.

This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Access Memory (SDRAM). One side (with memory chips) of the DIMM takes up one row on the motherboard.

Memory speed setup is recommended through SDRAM Configuration in 4.4.1

Chip Configuration.Install memory in any combination as follows:

DIMM Location	168-pin DIMM		Total Memory
Socket 1 (Rows 0&1)	SDRAM 8, 16, 32, 64, 128, 256MB	x1
Socket 2 (Rows 2&3)	SDRAM 8, 16, 32, 64, 128, 256MB	x1
	Total System Memory (Max 512 MB)	=

NOTE: Make sure the total installed memory does not exceeds 512MB. Otherwise, the system may hang during startup.

3.5.1 General DIMM Notes

•ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the memory of choice for best performance vs. stability.

•BIOS shows SDRAM memory on bootup screen.

•Single-sided DIMMs come in 16, 32, 64,128MB; double-sided come in 32, 64, 128, 256MB.

.3 SETUPH/W

Memory Installation

ASUS TUWE-M User’s Manual 21