2.Keyboard wake-up (3-pin KB_USBPWB)

This jumper allows you to enable or disable the keyboard wake-up feature. When you set this jumper to pins 2-3 (+5VSB), you can wake up the computer by pressing a key on the keyboard. This feature requires an ATX power supply that can supply at least 1A on the +5VSB lead, and a corresponding setting in the BIOS.

A85XM-A

KB_USBPWB

 

3

2

2

1

 

+5V +5VSB (Default)

A85XM-A Keyboard wake-up3.USB device wake-up (3-pin USBPWF)

Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh, power supply in reduced power mode).

USBPWF

A85XM-A

1

2

2

3

 

 

 

 

 

+5V +5VSB (Default)

A85XM-A USB device wake-up

•The USB device wake-up feature requires a power supply that can provide 500mA on the +5VSB lead for each USB port; otherwise, the system would not power up.

•The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

1-20

Chapter 1: Product introduction