Asus A8N-E USB port module cable, A8N-EIEEE 1394 connector, 8 . ATX power connectors, (24-pinEATXPWR1, 4-pinATX12V1), Chapter 1: Product introduction

7 . IEEE 1394a connector (10-1 pinIE1394_1 [orange])

This connector is for an additional IEEE 1394a port. Connect the IEEE 1394a module cable (orange) to this connector, then install the module to a slot opening at the back of the system chassis.

A8N-E

A8N-E IEEE 1394 connector

TPA1- GND TPB1- +12V GND

IE1394_1

1 TPA1+ GND TPB1+ +12V

Never connect a USB port module cable to the IEEE 1394a connector. Doing so will damage the motherboard!

8 . ATX power connectors(24-pin EATXPWR1, 4-pin ATX12V1)

These connectors are for an ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

• Use of a power supply unit (PSU) with a higher power output is recommended when configuring a system with more power- consuming devices. The system may become unstable or may not boot up if the power is inadequate.

•Make sure that your PSU can provide at least the minimum power required by your system.

	ATX12V	EATXPWR
	+12V DC GND	+3 Volts	+3 Volts
		-12 Volts	+3 Volts
		Ground	Ground
	+12V DC GND	PSON#	+5 Volts
		Ground	Ground
A8N-E		Ground	+5 Volts
		Ground	Ground
		-5 Volts	Power OK
		+5 Volts	+5V Standby
		+5 Volts	+12 Volts
A8N-E ATX power connectors		+5 Volts	+12 Volts
		Ground	+3 Volts

1 - 26 Chapter 1: Product introduction